1955 Chevy Belair – Red – Frame


Another frame was sourced for this build and the project will be started from here.

The frame was cross measured and checked out straight. Someone had all ready stripped the frame down, for the most part, and it was found sitting behind a garage up North of here. Universal 4-link, dropped disk brakes with tubular a-arms, 2-way adjustable coil-overs, and transmission cross member

Rack & pinion conversion, 9″ rearend, limited slip differential, Wilwood front and rear disk brakes, urethane suspension bushings.

Center brace kit

Bringing the center brace kit into the 4-link kit, test fit with the 406ci and Tremec 6-spd

Frame cleaned up and painted

The stack of new parts going back on again.

Getting there

Rolling chassis. Once those hard lines are straightened out the body will get set to start panel work.

Copyright 2022

Blog at WordPress.com.

%d bloggers like this: